Looking for an efficient, cost effective, and environmentally friendly heating/cooling system? A geothermal heat pump is the greenest way to go.
The basics
Even though the air temperature fluctuates a significant amount over the seasons, the ground absorbs nearly half the suns energy, keeping a more consistent temp under the surface. Geothermal heat pumps take advantage of this fact by employing earth loops– usually closed-system loops made of piping– to tap into stable underground temperatures and deliver heat or cooling when you need it.
These systems work by circulating an antifreeze solution in the loop between the ground source heat pump and your house, exchanging heat and distributing it through a conventional duct system to heat or cool your house.
Geothermal heating
It’s winter and the air outside is at its coldest. A geothermal heat pump system easily absorbs ground heat from the abundant supply stored below your home, and consumes less energy than a traditional pump system in the process.
Geothermal cooling
When warm summer weather rolls around, a geothermal heating and cooling system absorbs heat from your home and transfers it to the underground loop where it is then absorbed by the cooler earth. The geothermal heat pump uses the cool water returning from the ground to create cool, dehumidified air conditioning for your home.
Different kinds of loops
Depending on what your unique space and lifestyle requires, different kinds of earth loops may be installed.
Horizontal Loops
Often used when adequate land surface is available. Depending on geothermal system needs and space available, pipes are placed in trenches that range in length from 100 to 400 feet.
Vertical Loops
The ideal choice for a geothermal heat pump when available land surface is limited. Well drilling equipment is used to bore small-diameter holes from 100 to 400 feet deep.
Pond (Lake) Loops
Very economical to install when a large body of water is available for use by the geothermal heating and cooling system. Coils of pipe are simply placed on the bottom of the pond or lake to capture the geothermal energy.
Open loops (Well-Water Systems)
In ideal conditions, an open-loop application can be the most economical type of geothermal system. These use groundwater from a well as a direct energy source.
Images and descriptions via waterfurnace.com
Fun facts
- An EPA study of energy efficiency concluded geothermal energy is the most environmentally friendly heating/cooling system.
- The United States National Renewable Energy Laboratory concluded that geothermal energy is more efficient and cost-effective compared with conventional residential systems.
- Available everywhere in the United States, geothermal energy can be found underground virtually anywhere.
- Geothermal cost savings can be increased by geothermal energy incentives, available from federal, state, local, and utility sources.
Cost comparison
Energy and cost savings of geothermal heat pumps will vary by region and type of conventional system they’re compared with. But the energy cost of geothermal versus conventional HVAC systems will always be lower — and the geothermal system will always be greener.
Click to enlarge.
How much can you save in energy costs with a geothermal system? Calculate your home’s potential geothermal system cost savings
Looking for more information? Check out energy.gov for further resources: https://energy.gov/energysaver/geothermal-heat-pumps